The
Events
panel, offering three tabs:
Timing
: Events for Sync Status and Holdover, Frequency error, Input ref
erences and the internal oscillator.
GPS
: Events related to the GNSS receiver, including antenna cabling, track
ing less than the minimum number of satellites and GNSS receiver faults.
Systems
: Events related to the system operation, including minor and
major alarms being asserted, reboot, timing system errors and option
cards.
2.
In the
Events
panel, choose the
Timing
,
GPS
or
System
tab. Configure your Noti
fications (see below), and click Submit.
The columns under each tab are:
Event
—This is the event that will trigger the notification. The events under each tab
will vary according to context.
Mask Alarm
—Check here to enable an alarm mask. Enabling an alarm mask for
a given notification will prevent that notification from generating an alarm con
dition. Other notifications for that event and logging of the event will still occur.
SNMP Trap
—Check here to configure the event to trigger an SNMP Trap.
—Check here to configure the event to trigger an email notification.
Email Address
— Enter the address to which the email should be sent when
triggered by the event.
4.2 Notifications
CHAPTER
4
•
NetClock User Reference Guide
Rev.
16
229
Summary of Contents for NetClock 9400 Series
