Spectracom NetClock 9400 Series, User Reference Manual

Page: 145 / 467

interface), and that the next line is an
ipv6 address
line declaring an IPv6 address (if there
is one for the interface). No other lines or variations in spacing should be inserted before or
between these lines. No editing restrictions exist on
ospfd.conf
or
ospf6d.conf
files.
Example
zebra.conf
file with both IPv4, and IPv6 configured on the same port:
(Interface eth0 line, followed by IPv4 line and then IPv6 line)
*****************************************************
!
interface eth0
ip address 10.2.100.157/16
ipv6 address 2000:10:2::157/64
!
interface lo
ip address 10.10.14.1/32
ipv6 address 2000:10:10::1/64
*****************************************************
Example
zebra.conf
file with IPv4, and IPv6 configured on different ports:
(Interface eth0 line, followed by only IPv4 line, because no IPv6 address is configured on that
port. Interface eth1 line, followed by only IPv6 line, because no IPv4 address is configured on
that port)
*****************************************************
!
interface eth0
ip address 10.2.100.157/16
interface eth1
ipv6 address 2000:10:2::157/64
!
interface lo
ip address 10.10.14.1/32
ipv6 address 2000:10:10::1/64
*****************************************************
Example
zebra.conf
file showing the default file with no addresses configured:
(Interface eth0 line, with no lines following it because no addresses are configured on the port)
*****************************************************
!
interface eth0
2.15 Configuring NTP
CHAPTER
2
•
NetClock User Reference Guide Rev. 16
129