Spectracom Corporation
Model 9289
NetClock/NTP Network Time Provider Instruction Manual
3-1
3
Product Configuration
NOTE:
Screens shown in this manual are for illustrative purposes. Actual screens may vary.
Software common to multiple NetClock models may be used to generate these
screens. As a result, labels in the screens displayed may refer to units other than your
specific NetClock. Software operation should be common among these models, where
appropriate.
After installing the NetClock, verify that power is connected and wait for the device to boot up.
The front panel display provides certain configuration data on start-up. The right panel, by
factory default, displays the date and time (UTC). The left panel displays the unit’s hostname,
IPv4 address, mask, and gateway.
NOTE:
If using DHCP, the IP address will be assigned automatically. You may use a Web
browser to connect to this IP address and configure the NetClock through the Web
Browser User Interface (Web UI) (Figure 3-1).
Refer to Network Configuration with
DHCP
, Section 3.1.
Figure 3-1: Entering to the Configuration in the Web UI
Summary of Contents for 9289
Page 18: ...Model 9289 Spectracom Corporation NetClock NTP Network Time Provider Instruction Manual 1 8...
Page 36: ...Model 9289 Spectracom Corporation NetClock NTP Network Time Provider Instruction Manual 2 18...
Page 154: ...Model 9289 Spectracom Corporation NetClock NTP Network Time Provider Instruction Manual 3 118...
