Spectra Logic Spectra nTier300, Installation Manual

Page: 25 / 88

Rackmounting the nTier300 VTL
25
3. Slide the end of the slider (furthest from the latch) under the tab near the front of
the chassis so that the tab fits into the notch on the end of the slider, as shown in
Figure 2-10.
4.
With the screw holes in the slider aligned with the chassis screw holes, use a #2
Phillips screwdriver to install the screws from bag 1.
Screw one screw into each of the circled three holes, as shown in Figure 2-11. This
secures the slider to the chassis. Tighten the screws snugly. (If the circled holes
don’t align properly with chassis screw holes, install the three screws from bag 1
into other screw holes in the slider.)
Note:
There are extra screw holes in the slider. Only three of them are
needed to attach it to the chassis.
5.
Repeat Steps 2–4 to attach the second slider to the other side of the chassis.
o
Figure 2-10 Insert the slider under the tab.
o
Figure 2-11 Attach the slider to the chassis.
Tab
Front of chassis
Screws