Specac Atlas Power 15Ton, User Manual, Page: 62 / 84

User Manual
60
Display Screen after Increase Load Symbol Box Pressed from
Display Screen (C) Environment
For our example program ( P4 ), segment ( S4 ) is illuminated to change
the “ Pump up to ” load from its current 20 tons setting. However, in this
instance of a program creation and sequence of events, the previous
load holding setting has been at 7 tons for segment step (
S3 ), from a
Fast Release Load Rate function of the load initially being “ Pumped
up to ” and maintained for 0.3 minutes at 15 tons (segments ( S1 and
S2 ) steps). For this example program and use of the Autotouch 25T
press, the maximum load that can be set (increased to) is 25 tons,
hence the load range presented by the slide cursor on the gradient
scale is from a minimum 7.0 tons (already fixed at (
S3 )) to the
maximum of 25 tons.
Change the “
Pump up to ” load to apply accordingly from the slide
cursor position by touching and pressing the left side (lower load limit)
green box to reduce the tonnage load value or pressing the right side
(upper load limit) green box to increase the tonnage load value. Each
individual press of the box will change the load in step increments for
the appropriate press being used and be shown for its value in the
illuminated segment (
S4 ) underneath the Increase Load symbol. As
the load value is changed the slide cursor will move to the
corresponding position on the load range indicator.
Note: The load rise (or decrease) is in 0.2 Ton steps for the Autotouch
8T and 15T presses and 0.5 Ton steps for the Autotouch 25T press .