Specac Atlas Power 15Ton, User Manual, Page: 26 / 84

User Manual
24
Operation – Steps to Press a Sample
Powering up the Atlas™ Autotouch 8T/15T/25T Press
Note: Before switching on the Atlas™ Autotouch 8T/15T/25T
press ensure that the Safety Guard (5) is in its safe/down
position.
When operating the Atlas™ Autotouch 8T/15T/25T press for the first
time ensure that the power on/off switch (
1 ) on the front panel ( 2 ) is in
the off position. The power switch ( 1 ) has the markings O and I. The
switch is off when O is pressed level with the surface of the panel.
Now connect the Atlas™ Autotouch 8T/15T/25T press to a suitable
electrical supply using the supplied mains lead and plug. The mains
lead is first connected to the press at the rear into the power socket
(
3 ). Then the plug is connected to the electrical supply and the power
is switched on at the mains. Turn on the Atlas™ Autotouch 8T/15T/25T
press by the power on/off switch (
1 ) on the front panel ( 2 ). (The
indicator I is pressed level with the surface of the panel). The upper
edge of the switch (
1 ) shows a green color when in the on position.
Power to the press will also be indicated by illumination of the
electronic Autotouch Display Screen (
4 ). From start up the display will
show the working software version number and then default to the
Main Operation Screen (
MOS ). The Simple Operation Program ( PZ )
will be set as standard as the Default Program ( Def. Prog ) from
powering up, unless a previously created user program ( P1 to P6 ) has
been saved and stored in the memory for operation via the Options
(
Opt ) Display Screen environment “ Def. Prog ” option.
Note: The Simple Operation Program (PZ) forms the basis of the
instructions for the Operation Procedure and can be used
as a form of “Quickstart Guide”.
At initial startup a typical ( MOS ) will be presented as shown on the
following page. (An example ( MOS ) is shown for the Autotouch 25T
Press which has a minimum low Tonnage setting at 3.0 tons – range
is 3.0 Tons to 25.0 Tons).