Specac Atlas Power 15Ton, User Manual

Page: 8 / 84

User Manual
6
The sample is held in the pressing area prior to compression by use of
a lead screw and top anvil pressing face mechanism. Incorporated into
this mechanism are compression disc springs that allow for a slow
release of any load to the sample pressing procedure. In the
compression process the disc springs will be initially compressed
before full resistance is met to stop the travel of the piston. When any
stored load is released the disc springs will relax to their non-
compressed state and hence provide for a slow release of a full load.
An important part of the press is the safety guard mechanism. For any
operation of the press the safety guard must be in its closed (down)
position. Accidental raising of the guard, even if the press is under
load, will automatically abort the pressing operation and reduce the
load from the system to render it safe.
Please read section 3 on
pages 11 to 14 regarding safe operation before using the press
for the first time.
The Atlas™ Autotouch 8T/15T/25T press is provided with USB
connectivity if it is a requirement to operate the press remotely from a
computer system. For remote operation, please see Section 10 in this
manual.
The Atlas™ Autotouch 8T/15T/25T press is fully CE marked to comply
with strict European regulations.
WEEE Directive For Equipment Disposal
The symbol (above) on the back of the press indicates that this product
complies with the Waste Electrical and Electronic Equipment Directive
(WEEE). If this product is in use and was purchased within the
European Union, please contact your local sales agent or Specac to
make arrangements for disposal of this equipment.