Atlas™ Autotouch 8T, 15T and 25T Hydraulic Presses
53
Programming
The (
Pgm
) box button can be pressed directly from the (
MOS
),
only
when a user created custom program from (
P1
) to (
P6
) has been
loaded to run from the (
MOS
). (See details for a typical (
Pgm
) screen
display (
B
) environment accessed when program P4 is loaded on page
46.)
If any program from (
P1 to P6
) is loaded, the (
Pgm
) Display Screen
(
B
) access step from the (
MOS
) will allow a next step access route
through to an immediate program editing of the displayed program
segment steps as shown (see Editing Screen page 56),
but only
when
all of the (
P1
to
P6
) program registers are full. However, if a program
register (
P1
to
P6
) is empty, then pressing the (
Pgm
) box directly from
the (
MOS
) will step through to the next free (
P#
) register and fills the
empty program register with the segment details of the currently
loaded (
P#
) into the (
MOS
).
On initial supply of any of the Atlas Autotouch presses, the program
registers for (
P1
to
P6
) will be “empty” for creation of an users own
custom defined program sequences of applied loads, load hold times
and load release rate steps. When all six of these (
P#’s
) are filled and
have a user created and defined program stored, then if a new
program to be created for application is required, a specific (
P#
) from
(
P1
to
P6
) will require editing and restoring.
Note:
Access to the different user custom created programs as (
P1
) to
P6
) for their reprogramming, via editing and restoring, is
achievable following any
Directory
(
Dir
) step sequence path
from the (
MOS
) environment.
Summary of Contents for Atlas Power 15Ton
