Southwestern Industries TRAK 2OP M11, Safety, Installation, Maintenance, Service And Parts List

Page: 31 / 236

28
Southwestern Industries, Inc.
TRAK  2
OP
M11 Installation, Maintenance, Service, & Part List Manual
Figure 3.9
3.10 Moving the 2 OP Mill Around the Shop
The 2 OP mill was designed so it can be easily moved around the shop with the pallet jack that
comes with the machine. Please follow the instructions below when moving the machine.
I Machine relocation must be done by employees who are qualified and properly trained.
II When moving machine using the SWI supplied pallet jack, following conditions must be
satisfied:
1. The floor must be structurally rated to support and transport this machine (total machine
weight without any accessories is approximately 2500 lbs).
2. The floor must be relatively flat and with a maximum slope not to exceed ¼ inch /foot
anywhere along the transportation path.
3. Any steps, gaps or cracks in the floor that the pallet jack must go over, must be less than
½ inch high, wide, or deep.
4. The minimum door opening for machine to go through is 32 x 94 inches.
5. For best results, clear a 4’ wide path for transportation prior to actually moving the
machine.
TO MOVE THE MACHINE, PLEASE FOLLOW THE STEPS BELOW:
1. To prepare machine for relocation, move the X-axis to the approximate center, move the
Y-axis all the way toward the door (front) until the (soft) limit is reached, move the Z-
axis down until (soft) limit switch is reached.
2. Power down, and disconnect the machine’s electrical power cord, and any other
accessory cables connected to the machine.
3. Disconnect the machine’s compressed air supply hose, an d any other accessory hoses or
attachments connected to the machine.
4. Close front door and check to make sure that nothing else is attached to the machine.
5. Check to make sure that the floor is free of any objects which may obstruct the
movement of the pallet jack wheels or the machine along its transportation path.