Southwestern Industries TRAK 2OP M11, Safety, Installation, Maintenance, Service And Parts List

Page: 96 / 236

93
Southwestern Industries, Inc.
TRAK

2
OP
M11 Installation, Maintenance, Service, & Part List Manual
6. Rear Drain Plug – at the rear of the machine there is a drain plug in the floor of the
machine that can be removed to drain any coolant that collects in the rear compartment
of the machine. Over time as coolant splashes around, some coolant may accumulate in
this area.
5.11 Service Codes
Service codes are broken down into the following categories: software, machine setup,
diagnostics, user options/defaults.
All Service Codes are accessed in the SET-
UP Mode by pressing the soft key for “SERV CODES”.
The service codes can be found under one of the headings listed on the main screen. Press
CODE #, enter the number you want, then press SET.
Warning!
Certain service codes must be performed when servicing certain items on the 2 OP. Failure to do
so can lead to machine crashes and expensive repair work. Do not work on the TRAK 2 OP
unless you have been trained on these service codes.
Please see a table at the end of the service code section for the list of service codes that must be
run when certain machine components are worked on.
The Service Codes are divided into logical categories. The table below is a quick summary of the
service codes. More detailed information can be found below.
Software
Code Description Comment
33 Software, Firmware and PLC
versions
Displays current software versions and system settings.
141 Load configuration file from USB
thumb drive
To load configuration files from a USB thumb drive to the
TMX control.
142 Save configuration file to USB
thumb drive
To save the configuration files for reloading later. When
a computer replacement is necessary, saving the settings
to a thumb drive for reloading them later is highly
desirable.
316 Update Software Runs the routine that copies new software from a USB
thumb drive device to the ProtoTRAK system. Use this
routine to install new ProtoTRAK software.
400 Update Foreign Language MLS File Used to update the software language table. Please
contact your distributor for available languages and for
more information.
Machine Set-Up
122 Axis Calibration Using Offset
123 Calibration Mode Use to calibrate the TMX control
128 Backlash Calibration Constant Use to load backlash compensation for each axis.
500 X, Y Ball Lock Offsets Used to enter the offsets for ball lock
505 Over-travel Limits Used to setup and troubleshoot software limits.
510 Spindle Setup Used to calibrate spindle, orient the spindle in relation to
the ATC, and troubleshoot any spindle encoder related
issues.