Southwestern Industries TRAK 2OP M11, Safety, Installation, Maintenance, Service And Parts List

Page: 122 / 236

119
Southwestern Industries, Inc.
TRAK

2
OP
M11 Installation, Maintenance, Service, & Part List Manual
20. Tighten the four SHCS that secure the motor, tighten the jam nut of the belt adjusting screw.
21. Check X-Axis torque in 3 positions. Torque should be 10 in-lbs or less and within 3 in-lbs at all 3
locations
Service Codes to be Performed .
1. Service code 505 to check that the motor index angle is at 180° +/- 45°
2. Service code 520 to reset ATC tool positions.
3. Service code 500 to reset the ball lock location.
6.6 Ballscrew Replacement, Y Axis
Please refer to assembly drawing 27564-1 found at the back of this manual.
1. Remove the sheet metal and covers
a. Remove the rear cover for the Y-axis compartment.
b. Remove the drip pan that is secured to the motor mounting bracket.
c. Remove the front and rear sheet metal covers from the table.
d. Disconnect the ATC door from the door assist cylinder and remove the ATC door
e. Remove the ATC wiper cover.
f. Remove the six countersink screws that secure the Y-axis sheet metal cover to the Y-axis
casting.
2. Remove the Y-axis motor, motor bracket and belt.
3. Remove the Y-axis motor plate bracket
4. Remove the hex nut, star washer, pulley, ferrule, key and clamp nut from the back end of the
ballscrew.
5. Remove the four SHCS that secure the ATC magazine to the ATC slide, and remove the
magazine.
6. Remove the eight SHCS that secure the table to the support brackets and remove the table.
7. Remove the Y-axis sheet metal cover
8. Drive out the two roll pins of the Y-axis casting, located in between the casting mounting holes at
both ends.
9. Remove the seven SHCS that secure the Y-axis casting to the base.
10. Place a block of wood at the back of the Y-axis casting to prevent it from moving while hoisting,
see figure 6.6a.
11. Place a sling around the Y-axis casting and the head as shown in figures 6.6b and 6.6c.
Figure 6.6a