SoundCraft DC 2020, User Manual

Page: 181 / 190

Fostex G series (MIDI)
Additional Hardware Required
G series synchroniser card required, to be fitted to tape machine (Fostex Part no. 8330).
Transport Controls
All supported, machine sends back tallies.
Locate To Timecode
Supported.
Record Enable/Rehearse
Supported.
Jog/Shuttle
Not supported by Fostex G series machines.
Setup Notes
The following procedure should be followed on the front panel of the G24 to set-up the
parameters on the synchroniser card.
Hold down RCL, while held down press STO
Type 60, use "." to change to SIO MIDI.
Press STO.
Hold down RCL, while held down press STO
Type 63. Type 01.
Press STO.
Hold down RCL, while held down press STO
Type 64, use "." to change to ADFr oF.
Press STO.
Hold down RCL, while held down press STO
Type 65, use "." to change to change to Chuc oF.
Press STO.
Don’t forget to connect timecode output from the tape to CODE IN. See diagram below.
MIDI
IN
IN
MIDI
MIDI
OUT
OUT
MIDI
TIME CODE TRACK OUT
TIME CODE IN
)RVWH[*6HULHV
DC2020 Appendix A A.9