SoundCraft DC 2020, User Manual

Page: 49 / 190

Write. If the Fader is moved or a Switch is pressed this is written into the Mix Data,
creating a new Mix, or writing over any previous Mix data.
47
The mode of a Fader or Switch is changed by pressing the appropriate mode
switch, labelled SW for Switches and FDR for the Fader. Pressing the Mode switch
causes the mode to be cycled through in the following sequence: Manual, Read,
Armed and Write. Note that Manual Mode is not available whilst the Tape is running
with Mix on.
48
The WR (Write) and RD (Read) LEDs indicate which mode the Fader and
Switches are currently in. There are separate LEDs on each channel for Fader and
Switches. The modes are indicated as follows:
RD WR
Manual: OFF OFF
Read: ON OFF
Armed: ON ON
Write: OFF ON
49
The Control Group Assigned LEDs (CNTR GRP ASN) indicate which Control
Group, if any, each Input Channel is assigned to.
The Solo System
The Solo System works in two ways.
Solo
In Solo mode (the SIP LED on the Master Panel will be off) the Solo switches on
both the Channel and Monitor sections behave as Pre-fade Listens ,i.e. they feed the
PFL signal to the Headphones./Control Room Output.
Solo In Place
In Solo-In-Place mode (the SIP LED on the Master Panel will be on) the Solo
switches on both the Channel and Monitor sections will mute all other Channel or
Monitor sections respectively.
Any of the Channels or Monitors may be Solo-In-Place protected (safed) so that
they are not muted by other solo switches. This is done via the Monitor SIP Safe
and Channel SIP Safe pages.
Meters
The Meter may be used to monitor the Channel (send) or the Monitor (return)
section. The meters are switchable in groups of eight inputs. They are switched via
the Meterbridge Set-up page. The current setting is indicated by the SEND and
RETURN LEDs on the overbridge.
20
21
23
24
25
26
27
28
27
29
31
30
32
36
33
35
34
38
39
40
41
44
45
46
48
49
43
19
22
37
42
47
DC2020 Mono Inputs 4.9