SoundCraft DC 2020, User Manual, Page: 56 / 190

Auxiliary Master
There are four auxiliary buses. Each Input Module is able to put signals on each of
the four Aux buses. Aux1 & Aux2 are only fed from the Monitor path, post-fade.
Aux3 & Aux4 may be fed from The Channel path or the Monitor path, both
post-fade.
Auxiliary 1
1
The signal level from the Aux1 summing amp is controlled by the AUX1 pot.
2
The AFL switch causes the post-pot, post-cut signal to be sent to the Control-
room PFL/AFL system.
3
The CUT switch is a soft switch, i.e. this switch provides an input to the
Automation. The Automation , in turn, controls the electronic Cut circuit, which is
post-pot. The Automation also controls the adjacent CUT and ARM LEDS ( red
and amber respectively).
Auxiliary 2
4
The signal level from the Aux2 summing amp is controlled by the AUX2 pot.
5
The AFL switch causes the post-pot, post-cut signal to be sent to the Control-
room PFL/AFL system.
6
The CUT switch is a soft switch, i.e. this switch provides an input to the
Automation. The Automation , in turn, controls the electronic Cut circuit, which is
post-pot. The Automation also controls the adjacent CUT and ARM LEDS ( red
and amber respectively).
Auxiliary 3
7
The signal level from the Aux3 summing amp is controlled by the AUX3 pot.
8
The AFL switch causes the post-pot, post-cut signal to be sent to the Control-
room PFL/AFL system.
9
The CUT switch is a soft switch, i.e. this switch provides an input to the
Automation. The Automation , in turn, controls the electronic Cut circuit, which is
post-pot. The Automation also controls the adjacent CUT and ARM LEDS ( red
and amber respectively).
10
The AUX3 TO AUX1 switch, connects the Aux3 post-pot, post-cut signal to
the Aux1 Master signal path, at a point which is post the Aux1 Cut circuit.
Auxiliary 4
11
The signal level from the Aux4 summing amp is controlled by the AUX4 pot.
12
The AFL switch causes the post-pot, post-cut signal to be sent to the Control-
room PFL/AFL system.
4.16 DC2020 Auxiliary Master