6-84
HVR-Z1J/Z1U/Z1N/Z1E/Z1P/Z1C
2. Attachment procedure
1)
Install the S reel table assy
3
.
2)
Apply grease in the TG2 arm pivot shaft
B
.
Amount of grease: a ball of 1.0 mm diameter of grease
Re-application of grease to the point which is greased already
before is not necessary.
3)
Hold the TG2 arm block assy
5
with tweezers and insert it in
the TG2 arm pivot shaft
B
.
4)
Hook the tension spring (tension regulator spring)
4
on the
TG2 arm block
5
with tweezers so that the hook faces
downward.
5)
Hook the tension spring (tension regulator spring)
4
on the
LS chassis block assy (the third hook from the rear end).
6)
Hook the
A
portion of the band on the claw of the band adjuster
2
.
7)
Hold the band adjuster with tweezers as shown in
C
. Insert
the band into groove of the S reel table assy while rotating it,
and insert the adjuster’s dowel into the dowel hole
D
of the
LS chassis block assy.
8)
Install the band adjuster
2
with the screw (special head screw
M1.4
×
2.5)
1
.
Tightening torque: 0.059
±
0.01N•m (0.6
±
0.1kgf•cm)
9)
Perform the TG2 FWD Position Adjustment referring to section
2-4-1.
10) Perform the FWD Back-tension Adjustment referring to section
2-4-4.
11) Perform the Reel Torque Check referring to section 2-4-2.
1. Removal procedure
1)
Remove the screw (special head screw M1.4
×
2.5)
1
.
2)
Remove the band
A
of the TG2 arm block and remove the
band adjuster
2
.
3)
Remove the S reel table assy
3
.
4)
Remove the tension spring (tension regulator spring)
4
.
5)
Remove the TG2 arm block assy
5
.
2-3-11. Band Adjuster, S Reel Table Assy and TG2 Arm Block Assy
A
C
B
3
S reel table assy
1
Screw
(M1.4
×
2.5)
2
Band adjustor
Band
4
Tension spring
(Tension regulator)
5
TG2 arm
block assy
Shaft
B
Hole
D
Dowel
D
During installation, apply grease in
the TG2 arm pivot shaft hole.
Amount of grease:
a ball of grease of 1.0 mm diameter
Re-application of grease to the point
which is greased already before is not
necessary.
Third from
the rear end
Points to be noted
Key Points in Re-assembling
The spring hook
faces downward.
The spring hook
faces downward.
Apply Grease
