Sonnen eco 10, Installation And Commissioning Manual, Page: 18 / 65

10
Inspecting the storage system
▶
Inspect the system.
▶
If there is any suspected damage or loose parts,
stop installation, photograph the affected area,
and contact sonnen's service department.
Mounting the storage system
WARNING
Risk of injury lifting the storage
system!
The storage system is heavy.
▶
Wear safety boots.
▶
Ensure you have stable footing.
▶
Mount the storage system in an
upright position.
Two people are required to mount
the storage system.
CAUTION
Risk of injury, cabinet may fall
over!
Until the battery modules
are installed, the cabinets are
extremely top-heavy.
▶
Hold onto the storage system
during installation.
1. Install the mounting cleat
Tools needed:
‒
Power hand-drill
‒
3/16” bit
▶
Drill two holes into studs in the desired location
with a 3/16” drill bit 16 inches on center. Furr out
the wall as necessary. Secure the mounting cleat
to the wall with at least two 5/16" lag screws
driven to at least two inches of penetration.
Fig. 6 Mounting cleat
Fig. 7 Mounting cleat location
2. Place the leveling mat
▶
Clean the area where the storage system will be
installed and allow surfaces to dry.
▶
Place the leveling mat where the storage system
will be installed.
The leveling mat ensures a solid base for the
storage system, even on unleveled surfaces.
45”
+/- 1/8”
72”
+/- 1/8”
eco 5-12.5 eco 15-20