CIE-H14 User Manual Ver. 1.1
- 25 -
http://www.ezTCP.com
3.2
AT command
In the AT command mode, you can change some parameters through the serial port.
Checklists
Make sure of the connection between your PC and CIE-H14 using a RS232 cross
cable. All the parameters of the serial port between CIE-H14 and the Terminal of your
PC should be the same. In the AT command mode, you can change some parameters
through the serial port.
Figure 3-5 setting the communication mode to the AT command
Procedures
Figure 3-6 procedures for configuration with AT command
Division
Available parameters
IP Address related items
Local IP Address, DHCP, PPPoE, Subnet Mask,
Gateway IP Address, DNS IP Address, ···
A TCP connection related items
Local Port, Peer Address (IP Address or Host name),
Peer Port, ···
Option
ESC code sending option, timeout, ···
Table 3-1 parameters which are available to change with AT command
Including above items, rest of parameters can be set by ezManager
