SOLARFOCUS Therminator II, Installation Manual

Page: 34 / 44

Initial commissioning
34 Installation manual thermi
nator
II touch
8
Initial commissioning

Initial commissioning of the boiler may only be
performed by qualified personnel (SOLARFO-
CUS service technician or SOLARFOCUS
specialist service partner) (= condition for
guarantee, warranty).
The boiler is hydraulically connected.
The heating system is filled with water and has
been vented.
The boiler is electrically connected.
Connect the boiler to the mains power supply.
Carry out the commissioning routine in the boiler
control.

After having completed initial commissioning,
the completed commissioning form should be
returned to SOLARFOCUS. If this does not
happen, then for guarantee and warranty
claims of any kind the date of shipment from
the manufacturer to the dealer (according to
the delivery note and invoice) will be used.
Output setting
During commissioning, set the nominal output 1 of
the boiler, the system type 2 , and the boiler oper-
ating modes bought 3 .
Fig. 8-1
The output is controlled (ID fan control) based on
parameters set at the factory. No further setting work
is required for this.
9
Annex
9.1 Flue gas pipe: Hole for emission
measurement
Make the hole for the emission measurement
according to the following images (recommenda-
tion according to standard).
If these specifications cannot be implemented,
then make the measuring point after a calming
section, i.e. after the longest straight section of the
pipe. The tube orientation (horizontal, vertical,
oblique) plays no role in this case.
In any case, place the measuring point before any
existing draught stabiliser.
You can find the function for carrying out the emis-
sion measurement in the boiler operation manual,
keyword:
Chimney sweep function.
Flue gas pipe vertical
1