SOLARFOCUS Therminator II, Installation Manual

Page: 25 / 44

Installation
Installation manual thermi
nator
II touch 25
5-6_003
Remove front and rear side of housing
Release the screws (TX15) on the front and back of
the housing and remove the housing sections, .
Position the housing on the left side next to the boiler.
5-7_005
Adjust housing, fit connecting hose
Position the housing so that the two connection noz-
zles
1 are aligned (adjust the height with the adjusta-
ble feet 2 , SW 12).
Fit the connection hose 3 over the connection nozzles
and attach with the two hose clamps (SW7).
5-8_Boiler power element
Connect the cable to the power element
Remove the front cover (red) from the boiler.
Route the following cables across the back of the boil-
er and into the cable duct to the power element
- Suction turbine
- Container auger motor
- Filling level sensor on the container
Connect all routed cables to the boiler power element
1 Plate slide back-burning protection: X25
2 Feed auger temperature sensor: X33
3 Feed auger motor: X23 (8)
4 Suction turbine: X3 (2)
5 Container auger motor: X22 (18)
6 Filling level sensor: X49
5-9_006
Install cover, connect hoses
Mount the front cover 1 .
Mount flange cover 2 (2-piece) with 9 x self-tapping
screws M4x10, TX20 on the boiler cover.
Fit front and back housing sections.
Connect hoses (fix with hose clamp SW10) 
35
2
1
2
3
4
3
2
5
1
6
Suction hose (pellets)
Return air hose
1