SOLARFOCUS Therminator II, Installation Manual

Page: 24 / 44

Installation
24 Installation manual thermi
nator
II touch
5.9.6 Installation sequence
Tools required:
Bit TX15 / TX20 ♦ Side cutter ♦ Wrench SW 7/12/17 ♦ Snap-off blade knife
5-3_001
Open side cladding
Boiler thermi nator II touch must be fully set up and
aligned.

The intermediate pellet store can only be installed
on the left side of the boiler. Mount the shaker mo-
tor
(optional item Automatic switchover of log wood to pellets )
on the right side of the boiler for better accessibility!
Separate the pre-punched part from side cladding
(using wire cutters).
Cut out the insulation behind the side cladding.
5-4_002
Removing the flange plate
Release 4 hex nuts M10 (SW17) 1 and remove the
flange plate 2 .
5-5_004
Install the feeder unit

If the vessel has an existing shaker motor (Item
Automatic switchover unit from logs to pellets ):
BEFORE installing the feeder unit, permanent-
ly remove the cover (housing) of the shaker
motor.
Ideally, however, the shaker motor is located
on the right side of the boiler.
Insert feeder unit 1 incl. flange seal 2 onto the thread-
ed bolts and fasten with 4 x hex nuts.
Route the following cables in the cable duct 3 on the
inside of the boiler cladding:
- Plate slide back-burning protection
- Temperature sensor for the feed auger
- Feed auger motor
2
1
1
2
3