![background image](http://html1.mh-extra.com/html/snell-and-wilcox/prefix-cpp100/prefix-cpp100_operators-manual_1309061069.webp)
CPP100
SECTION 6
CPP1OPS
25/10/06
www.snellwilcox.com
Version 1 Issue 6
6.37
With the user definable key window a particular
area of the picture could be excluded as shown
below.
The Key Window can be highlighted by selecting a
Border
to be displayed around the key window.
Please note that when the key window is chosen it
is applied to both the PROGRAM and MONITOR
outputs. Hence the processing is applied to the
PROGRAM and MONITOR outputs. The Border is
only visible on the MONITOR output.
Log Server Name
The facility exists to log systems events using the
RollCall PC log viewer application software (refer to
Appendix 4 – Section 12 for field information).
Memory Menu
This menu allows unit configuration and settings to
be stored and recalled.
In the
Store User
sub-menu there are eight initially
empty memory slots. To recall one of the user
defined memories use the
Recall User
sub-menu.
Set Name
allows the name of the user memories to
be selected by the user.
There are a set of pre-defined memory settings for
specific applications and these can be found in the
Recall Preset
sub-menu.
Current Operating Conditions
When the panel display shows the ‘normal’ status
page the current memory name is displayed on the
second line. If any setting is different to that
memory either “(Modified)” or “(Mod)” will be added
to the end of the name to show that the current
configuration is a modified version of that store.
The current settings, including the network name
and address, are maintained in a special store that
is recalled when the Prefix is powered on. Ten
seconds after any setting is changed it is written to
this store so that if the unit is subsequently powered
off then on again its configuration will not be lost.
Store User
The eight user defined memories store all the
PREFIX configuration settings such as filters,
decoder parameters and video configuration. The
only exceptions to this are the Network Address and
Name, these are only changed and stored under
the
Sytem
menu.
Using the memory.
1. Set up PREFIX with the desired settings such as
SDI A, VITS All On
Recursive On
Median On
2. Use the
Set Name
sub-menu, and select the
name for the memory. You could adopt a simple
numbering system , use a channel name or a
generic setting such as film or sports.
3. Store the memory. To do this enter the
Store
User
sub-menu and choos which memory slot is to
be used. Press SELECT when the desired slot has
been chosen.
Area to be excluded from
processing selected by
user defined key window
and Key window invert
Memory
▶
Recall Preset
▶
Recall User
▶
Store User
▶
Set Name