![background image](http://html1.mh-extra.com/html/snell-and-wilcox/prefix-cpp100/prefix-cpp100_operators-manual_1309061110.webp)
CPP100
SECTION 10
CPP1OPS
25/10/06
www.snellwilcox.com
Version 1 Issue 6
10.1
Appendix 2
Status and Warning Messages Summary
A number of different messages are displayed on the
front panel NORMAL display or on the ‘ShoeBox’
status display. In addition status information can be
found in different parts of the menu structure and
from the front panel buttons.
Source Status
The top line of the NORMAL panel display is used to
identify the source selected and the status.
The source is identified as follows
SDI A
Serial Digital Interface Input A
SDI B
Serial Digital Interface Input B
Comp A
Composite Input A
Comp B
Composite Input B
The status messages are
No I/P
A valid video input has not been
detected at the selected source.
Please check that the correct
source has been selected and that
a valid source has been connected
to the unit.
Wrong Std
The video standard of the selected
source does not match the selected
source standard for the unit. Check
that the selected standard is
correct. Check that the source is
valid. This error should not occur if
the standard is set to Auto.
525
525 line SDI source signal
625
625 line SDI source signal
PAL-I
PAL-I composite video signal
PAL-N
PAL-N composite video signal
PAL-M
PAL-M composite video signal
NTSC
NTSC composite video signal
If there is an input error the RED status LED in the
INPUT button will flash.
Genlock Status Menu
---
Unable to Genlock.
Check the reference signal is valid or
that the input is valid.
Off
Genlock Off
Input
Genlocked to input if a valid reference
input is not present.
Ref
Genlocked to reference input
If there is a Genlock error the GREEN status LED in
the Genlock button will flash.
EDH Status Menu
None
EDH not present
OK
EDH present no errors
Errors
EDH is present with errors
Off
EDH Turned Off
Status Messages
These are displayed on the bottom line of the display
at the left hand side.
Message
Meaning
PATTERN
Test pattern is turned ON
REMOTE
The unit is being accessed
from a remote RollCall
unit
FREEZE
Picture Freeze is turned ON
PANEL LOCKED
Front panel lock is ON
BYPASS MODE
Filters are turned OFF
If more than one of these messages is valid then the
display automatically loops round.