![background image](http://html1.mh-extra.com/html/snell-and-wilcox/prefix-cpp100/prefix-cpp100_operators-manual_1309061022.webp)
CPP100
SECTION 4
CPP1OPS
25/10/06
www.snellwilcox.com
Version 1 Issue 6
4.1
Getting Started
Connect up the unit so that there is a Analogue
Composite video signal applied to the composite
input or a Serial Digital video signal applied to the
SMPTE259M-C serial input. For Composite inputs
REMEMBER to fit a termination if the video loop
through is not used. Either one of the 2 serial outputs
can be used. A reference signal may be connected if
required.
The front panel is opened by using the two black
catches at either end of the panel. We have found the
best way of opening the panel is to use your thumbs
to release the catches and then ease the panel
sufficiently forward.
Turn the unit on. The green LED to the left of the
ON/OFF switch should be illuminated, and the fan
should be audible.
CPP100-D Version Only
The front panel display will indicate that the unit is
powering up and that the Xilinx and CPU devices are
being configured.
The display on the decoder card will indicate that the
Xilinx devices are being configured. The bar at the
end of the message will rotate during this process.
A scrolling message will then display the unit’s name
and the configuration status.
The initialisation sequence is now complete and the
output should be the decoded input.
SNELL & WILCOX
CPP-100
Booting Xilinx..
SNELL & WILCOX
CPP-100
Booting....
LED