SMC Networks 8724ML3 - annexe 1, Management Manual

Page: 485 / 820

F
LASH
/F
ILE
C
OMMANDS
4-85
for file names on the TFTP server is 127 characters or 31 characters for
files on the switch. (Valid characters: A-Z, a-z, 0-9, “.”, “-”, “_”)
• Due to the size limit of the flash memory, the switch supports only two
operation code files.
• The maximum number of user-defined configuration files depends on
available memory.
• You can use “Factory_Default_Config.cfg” as the source to copy from
the factory default configuration file, but you cannot use it as the
destination.
• To replace the startup configuration, you must use startup-config as the
destination.
• Use the copy file unit command to copy a local file to another switch in
the stack. Use the copy unit file command to copy a file from another
switch in the stack.
• The Boot ROM and Loader cannot be uploaded or downloaded from
the TFTP server. You must follow the instructions in the release notes
for new firmware, or contact your distributor for help.
• For information on specifying an https-certificate, see “Replacing the
Default Secure-site Certificate” on page 3-82. For information on
configuring the switch to use HTTPS for a secure connection, see “ip
http secure-server” on page 4-42.
Example
The following example shows how to upload the configuration settings to a
file on the TFTP server:
Console#copy file tftp
Choose file type:
1. config: 2. opcode: <1-2>: 1
Source file name: startup
TFTP server ip address: 10.1.0.99
Destination file name: startup.01
TFTP completed.
Success.
Console#