M
IRROR
P
ORT
C
OMMANDS
4-201
port monitor
This command configures a mirror session. Use the
no
form to clear a
mirror session.
Syntax
port monitor
interface
[
rx
|
tx
|
both
]
no port monitor
interface
•
interface
-
ethernet
unit
/
port
(source port)
-
unit
- Stack unit. (Range: 1-8)
-
port
- Port number. (Range: 1-25/49)
•
rx
- Mirror received packets.
•
tx
- Mirror transmitted packets.
•
both
- Mirror both received and transmitted packets.
Default Setting
No mirror session is defined. When enabled, the default mirroring is for
both received and transmitted packets.
Command Mode
Interface Configuration (Ethernet, destination port)
Command Usage
• You can mirror traffic from any source port to a destination port for
real-time analysis. You can then attach a logic analyzer or RMON probe
to the destination port and study the traffic crossing the source port in a
completely unobtrusive manner.
• The destination port is set by specifying an Ethernet interface.
• The mirror port and monitor port speeds should match, otherwise traffic
may be dropped from the monitor port.
• You can create multiple mirror sessions, but all sessions must share the
same destination port. However, you should avoid sending too much
traffic to the destination port from multiple source ports.
Summary of Contents for 8724ML3 - annexe 1
