C
OMMAND
L
INE
I
NTERFACE
4-190
auto-negotiation is disabled, you must manually specify the link
attributes with the
speed-duplex
and
flowcontrol
commands.
• If autonegotiation is disabled, auto-MDI/MDI-X pin signal
configuration will also be disabled for the RJ-45 ports.
Example
The following example configures port 11 to use autonegotiation.
Related Commands
capabilities (4-190)
speed-duplex (4-188)
capabilities
This command advertises the port capabilities of a given interface during
autonegotiation. Use the
no
form with parameters to remove an advertised
capability, or the
no
form without parameters to restore the default values.
Syntax
[
no
]
capabilities
{
10000full
|
1000full
|
100full
|
100half
|
10full
|
10half
|
flowcontrol
|
symmetric
}
•
10000full
- Supports 10 Gbps full-duplex operation
•
1000full
- Supports 1 Gbps full-duplex operation
•
100full
- Supports 100 Mbps full-duplex operation
•
100half
- Supports 100 Mbps half-duplex operation
•
10full
- Supports 10 Mbps full-duplex operation
•
10half
- Supports 10 Mbps half-duplex operation
Default Setting
• 1000BASE-T: 10half, 10full, 100half, 100full, 1000full
• 1000BASE-SX/LX/LH: 1000full
• 10GBASE-LR: 10000full
Command Mode
Interface Configuration (Ethernet, Port Channel)
Console(config)#interface ethernet 1/11
Console(config-if)#negotiation
Console(config-if)#
Summary of Contents for 8724ML3 - annexe 1
