Change the numbers by highlighting them and using the
Up
and
Down
arrow buttons to increase or decrease the number.
The factory default Port settings are:
Remote Admin:
8200
Remote
Callback:
8201
Remote
Watch:
8016
Remote
Search:
10019
Remote
Audio:
8116
Figure 45 — Port Numbers setup screen
NOTE: The system restarts automatically after changing the port settings.
NOTE: Do NOT use the same port number for two different programs, otherwise, the DVR cannot
be connected with the PC running or WebGuard.
CAUTION: When changing the port settings, you must change the port settings on the
PC running RAS or WebGuard as well. Refer to the RAS manual for details.
Selecting
DHCP
from the Type and highlighting
Save
button reads the current IP address of the DVR
configured by DHCP (Dynamic Host Configuration Protocol) network.
Figure 46 — LAN (DHCP) setup screen.
Selecting
ADSL (with PPPoE)
allows you to set up the ADSL network.
NOTE: ADSL and modem cannot be configured at the same time. If the DVR is configured by
modem, the
ADSL (with PPPoE)
will not be selected.
