A P P E N D I X B
Connecting your room control system to your projector
91
smarttech.com/kb/170295
Command
Response
get gateway
gateway=[current network gateway]
get primarydns
primarydns=[current primary domain server]
get macaddr
macaddr=[current MAC address]
These commands control your network settings.
Command
Command target range
Response
set network [target]
=on
=off
network=[current]
set dhcp [target]
=on
=off
dhcp=[current]
set ipaddr [target]
=0.0.0.0 to =255.255.255.255
ipaddr=[current]
set subnetmask [target]
=0.0.0.0 to =255.255.255.255
subnetmask=[current]
set gateway [target]
=0.0.0.0 to =255.255.255.255
gateway=[current]
set primarydns [target]
=0.0.0.0 to =255.255.255.255
primarydns=[current]
System controls
These commands enable you to switch system settings and access system information.
These commands inform you of the current system settings. These commands are unavailable when
the projector is in Standby mode.
Command
Response
get cppower
cppower=[current XCP power setting]
get autosignal
autosignal=[current auto signal detection setting]
get lampreminder
lampreminder=[current lamp reminder setting]
get highbrightness
highbrightness=[current lamp brightness setting]
get autopoweroff
autopoweroff=[current auto power off setting]
get zoom
zoom=[current zoom setting]
get projectorid
projectorid=[current projector ID number]
get hposition
hposition=[current horizontal position offset setting]
get vposition
vposition=[current vertical position offset setting]
get aspectratio
aspectratio=[current projector aspect ratio]
get projectionmode
projectionmode=[current projection mode]
