SMART LightRaise SLR60wi, User Manual

Page: 60 / 138

C H A P T E R 6
Maintaining your projector
52 smarttech.com/kb/170295
To put the new lamp module into the projector
1. Remove the new lamp module from its packaging.
2. Carefully place the lamp module into the projector using the handle on the top of the module, and
then tighten the captive screw with the Phillips screwdriver.
C A U T I O N
Do not over-tighten the screws.
3. Connect the lamp module’s power plug into the power receptacle.
4. Place the lamp protection film over the slot, carefully replace the lamp cover and then tighten the
captive screw.
To finish the projector lamp module installation
1. Connect the projector power cable to the wall outlet, and then turn on the projector.
2. Press the
Power button once on the remote control or XCP to confirm that the projector is
operating and that the lamp module is correctly installed.
3. Adjust the projector image if necessary (see Adjusting the image on page 26).
4. Access the service menu to reset the lamp hours (see Resetting the lamp hours on page 56).
5. Activate the projector’s alert e-mails and lamp warnings if they’ve been deactivated (see E-mail
alerts on page 79 and Control panel on page 76).