Skoda Fabia II 2007, Workshop Manual

Page: 73 / 165

1 - Flywheel
❑ make sure the centering
pins are correctly fitted
❑ The locating face for the
clutch lining must be
free from grooves, oil
and grease
❑ Removing and Installing
⇒ Engine; Rep. gr. 13
2 - Clutch disc
❑ Diameter ⇒ Electronic
Catalogue of Original
Parts
❑ Fitting position: The
spring cage points to‐
wards the pressure
plate
❑ centering for vehicles
with 1.2 ltr and 1.4 ltr en‐
gines ⇒ page 70
❑ centring for vehicles
with 1.4 ltr (TDI) and 1.6
ltr engines ⇒ page 70
❑ slightly grease the ser‐
ration
Note
Clean the drive shaft serration and
hub serration on used clutch discs,
remove corrosion. Apply a very thin
layer of grease - G 000 100- onto the
serration. Subsequently move the
clutch disc up and down on the drive
shaft until the hub fits smoothly on
the shaft. Remove all excess
grease.
3 - Pressure plate
❑ removing and installing for vehicles with 1.2 ltr and 1.4 ltr engines ⇒ page 70
❑ removing and installing for vehicles with 1.4 ltr (TDI) and 1.6 ltr engines ⇒ page 70
❑ Check the extremities of the membrane spring ⇒ page 70
4 - Screw M6 - 13 Nm; screw M7 - 20 Nm
❑ loosen or tighten gradually and crosswise
❑ assign according to the ⇒ Electronic catalogue of original parts .
Fabia II 2007 ➤ , Fabia II 2009 ➤ , Fabia II 2011 ➤ , Rapid 2011 ➤ , R ...
Gearbox 02T - Edition 05.2014
3. Repairing clutch
69