Skoda Fabia II 2007, Workshop Manual

Page: 156 / 165

– If present, remove heat shield for drive shaft -arrows-.
– Remove drive shaft from flange shaft ⇒ Chassis; Rep. gr. 40 .
Proceed as follows for both gasket rings
– Tie up the drive shaft as far as possible. Avoid damaging the
paintwork on the drive shaft during this operation.
– Position the catch pan under the gearbox.
– Release fixing screw for flange shaft; while doing so prevent
flange shaft from turning along.
– Remove the flange shaft together with the pressure spring.
– Remove the gasket ring of the flange shaft.
Note
♦
Do not damage the bushing for the right gasket ring as this will
cause leaks.
♦
replace bushing if damaged ⇒ page 126 .
1.2 Install
For left gasket ring
– Drive the new seal ring in up to the stop, do not twist the seal
ring.
For right gasket ring
– Drive the new gasket ring into the bushing up to the stop, do
not twist the gasket ring.
Proceed as follows for both gasket rings
– Fill half the space between the sealing and dust lip with sealing
grease -G 052 128 A1- .
The further installation occurs in reverse order, while paying at‐
tention to the following:
– Check gear oil level, if necessary fill up to lower edge of filler
hole ⇒ page 112 .
– Check the axial measurement of the vehicle ⇒ Chassis; Rep.
gr. 44 .
Tightening torques
Flange shaft to gearbox ⇒ page 154
Coupling rod to anti-roll bar ⇒ Chassis; Rep. gr. 40
Drive shaft to flange shaft ⇒ Chassis; Rep. gr. 40
Fabia II 2007 ➤ , Fabia II 2009 ➤ , Fabia II 2011 ➤ , Rapid 2011 ➤ , R ...
Gearbox 02T - Edition 05.2014
152
Rep. gr.39 - Final drive - differential