Unlock the actuating rod/master cylinder from the clutch pedal as
follows:
– Pull clutch pedal slightly into the passenger compartment.
– Press both sides of the support inwards using the pliers -
T10005- -arrows-
– Unscrew the two lower fixing nuts -arrows-.
– Remove the bracket -A- from the front wall -B-.
• The master cylinder is locked into position with the bracket.
• When removing the bracket, the master cylinder in the engine
compartment must be held by a 2nd mechanic.
Install
Installation is performed in the reverse order, pay attention to the
following points:
Note
Position self-locking nuts -1- and -2- for bracket -3- on front wall
and tighten.
– The support -A- must be located on the actuating rod -B- of
the master cylinder.
– To click in the support -A-, press the clutch pedal towards the
front wall in -direction of arrow-. While doing so, make sure it
catches correctly in the support.
– Connect the connector to the clutch pedal switch - F36- .
– Install the footwell vent ⇒ Heating and Air Conditioning; Rep.
gr. 87 .
Fabia II 2007 ➤ , Fabia II 2009 ➤ , Fabia II 2011 ➤ , Rapid 2011 ➤ , R ...
Gearbox 02T - Edition 05.2014
45
