8 - Stop
❑ for the clutch pedal
9 - Bearing bolt
❑ always replace ⇒ Electronic Catalogue of Original Parts
10 - Over-centre helper spring
❑ depending on the equipment version, a tension spring or an over-centre helper spring is installed
❑ Assign components via the ⇒ Electronic catalogue of original parts
❑ removing and installing
11 - Clutch pedal
❑ removing and installing with over-centre helper spring
❑ removing and installing with tension spring
12 - Bushing
13 - Tension spring with vibration damper
❑ depending on the equipment version, a tension spring or an over-centre helper spring is installed
❑ Assign components via the ⇒ Electronic catalogue of original parts
❑ is inserted on the bracket -Pos. 3- and on the clutch pedal
❑ removing and installing
14 - Cap
15 - Support
❑ only replace if the master cylinder has been removed
❑ removing and installing
16 - Master cylinder
❑ removing and installing
17 - Clamp
❑ to remove and install the tube-hose line pull out retaining clip up to the stop
❑ is pulled out from the side on certain master cylinders
18 - Gasket
❑ always replace ⇒ Electronic Catalogue of Original Parts
❑ stick onto the master cylinder
19 - Supply hose
❑ out of plastic
20 - Clutch position sender - G476-
❑ for vehicles with start-stop system
❑ Assign components via the ⇒ Electronic catalogue of original parts
❑ removing
❑ installing
❑ can be checked in the “targeted fault finding” ⇒ Vehicle diagnostic tester
Fabia II 2007 ➤ , Fabia II 2009 ➤ , Fabia II 2011 ➤ , Rapid 2011 ➤ , R ...
Gearbox 02T - Edition 05.2014
30
