SKF IPM 12, Operating Instructions Manual

Page: 95 / 108

Page 95
EN
Trouble shooting procedures, Table 2 from 3
Malfunction Cause Remedy
PGA 3 software has crashed aulty input Use the numeric keypad to enter the letter ”s” = search
No display on PGA 3 A signal is measured at a deactivated measuring
point
Fault pending Disconnect measuring point
Press ”RESET” on selected IPM 12
Service key not work Start up mode
Mixed start mode
Exit mode. Disconnect signal from terminal 31/32
(see 5.2.2).
Master can only exit mode when
- no malfunction of slaves
- no malfunction of master.,
laves exit staert mode after a reset of the corresponding
device.
Important: now enter full threshold values. => If a
slave malfunction and the master has to exit the start
mode, force slaves into the start mode. Remedy pro-
blem (by running the service routine- see 7.1.2 -
Suppressing monitoring); reset master.
9. Trouble shooting procedure