Sitex SP38 Autopilot, Installation And Operation Manual

Page: 52 / 162

Sitex SP38 Installation and Operation
Document PN 29010101 V2r0
- 51 -
Control Head
Mounting Control Head
The SP38 Control Head is typically mounted in the vessel’s wheelhouse. It can also be
mounted in more exposed locations, such as on a flying bridge, since it is fully splash-proof
(however be advised that the SP38 Control Head is not submersible).
When ordered as part of a P-Series System, each Control Head is supplied with a flush
mounting kit, including a bracket for flush mounting. The flush-mount is meant to be used
when the Control Head is installed inside the boat. If using the optional Deck Mount or
commonly known “Trunnion Mount” bracket kit; the unit is generally mounted on the console
or in an overhead bulkhead location.
Complete instructions, including drilling and cutting templates for each type of mounting, are
included with each kit.
Figure below shows the back of the Control Head for installation
Figure 26 - SP38 Control Head - Rear View
Installation
Control head DC Power Receptacle
Cable PN 61110063.
plug for 6m drop cable female to
male via TEE connector to SPU. see
Fig3 SP38 system Block Diagram
Ethernet for SW
programming