Simrad TV80, Reference Manual

Page: 55 / 306

406388/B
53
If you wish to connect your Processor Unit to a ship network, you must provide the
computer with two Ethernet adapters. Use one adapter for the communication with the SR70
or SR15 Receiver Unit, and one for the local area network.
Procedure
1 Close all the programs that are running on the Processor Unit.
2 Open the
Network Connections
dialog box.
This procedure is made for the Microsoft ® Windows ® 10 operating system.
a In the bottom-left corner of your desktop, select the Windows ®
Start
button.
b On the menu, select
Settings
.
c Observe that the
Settings
dialog box opens.
d Select
Network and Internet
.
e At the bottom of the dialog box, select
Change adapter options
.
f Select the network adapter you are going to use; then right-click and select
Properties
on the short-cut menu.
g On the list of connections, select
Internet Protocol 4 (TCP/IPv4)
, and then
Properties
.
This procedure is made for the Microsoft
®
Windows
®
7 operating system.
a In the bottom-left corner of your desktop, select the Windows ®
Start
button.
b On the right-hand side of the
Start
menu, select
Control Panel
.
c Observe that the Control Panel opens.
d Select
Network and Sharing Center
.
(If the Control Panel is shown with categories, select
View network status and
tasks
.)
e On the left-hand menu, select
Change adapter settings
.
f Click once on your network adapter to select it, then right-click and select
Properties
on the short-cut menu.
g On the list of connections, select
Internet Protocol 4 (TCP/IPv4)
, and then
Properties
.
3 Select
Use the following IP address
, and type the IP address and network mask.
• IP Address:
192.168.1.30
• Subnet mask:
255.255.255.0
4 Select
OK
to save the chosen settings, then close all the dialog boxes.
Getting started