Simrad TV80, Reference Manual

Page: 50 / 306

48
406388/B
all the measurements, the channel the information is coming through and if the TV80
is acknowledging it. The
Measurements
dialog box will vary according to the selected
communication port.
Procedure
1 Select the
Setup
icon.
The icon is located under the
Main
menu. It is used to open the
Setup
menu.
2 On the
Setup
menu, select
Installation
.
Observe that the
Installation
dialog box opens.
3 Observe the
I/O Setup
page on the right side of the
Installation
dialog box.
Every interface is presented as a small "block diagram".
4 Select the inspection point at the left of the “block diagram” you want to check.
The
Measurements
dialog box opens.
5 Check if the TV80 is receiving information from a specific sensor.
You can see if the TV80 is taking the measurement as a valid value (“y” letter) or
not (“n” letter).
Selecting Normal mode
In order to receive data from the catch sensors installed, you must set the TV80 to Normal
operational mode.
Context
The
Operation
function controls the operational mode of the TV80. You can set it to Normal
or Replay . The Normal mode allows the TV80 to receive sensor data, process it, and finally
present the relevant information.
Simrad TV80 Reference Manual