Simplicity AGCO Allis 500 Series, Service And Repair Manual

Page: 173 / 201

13 - 5
CONTROL PANEL SERVICE
Control Panel Removal and Installation
1. Remove the cover (Ref. 14, Figure 1) from the back
of the control panel.
2. Disconnect the wire harness from the back of the
ignition switch (D, Figure 4), headlight switch (B), and
PTO switch (A).
NOTE: Refer to COMPONENT LOCATION & REPLACE-
MENT, Section 7 for switch removal and installation
instructions.
3. Remove the parking brake knob (E, Figure 4). Gear
models also remove the shift lever knob (C).
4. Using a flat-blade screw driver, pry the edges of the
control panel out of the seat deck.
Install in reverse order of removal.
SEAT DECK SERVICE
Seat Deck Removal and Installation
NOTE: If the seat assembly is also being removed, dis-
connect the seat switch wire harness from the switch
itself. If the seat and hinge plate are being removed as
an assembly, follow the seat switch wire harness down
to the shrink wrap, remove the shrink wrap, and unplug
the wire harness from the main harness.
1. Disconnect the ignition switch, PTO switch, and
headlight switch wire harnesses from the back of the
control panel.
2. Remove the capscrew (E, Figure 5) lockwashers (G),
and nuts (H) securing the hinge pin bar (F) to the rear
frame wrapper (D).
3. Remove the seat and slide assembly (A).
4. Remove the upper capscrews (B).
5. Remove the lower capscrews (I) securing the seat
deck (C) to the frame.
6. Remove the seat deck.
Install in reverse order of removal.
Figure 4. Control Panel Removal
A. PTO Switch
D. Ignition Switch
B. Headlight Switch E. Parking Brake Knob
C. Shift Lever Knob
13 Seat & Seat Deck Service
Control Panel / Seat Deck Service
A
B
C
D
E
A
C
D
E
F
G
H
B
I
Figure 5. Seat Deck Removal
A. Seat and Slide Assy.
F. Hinge Pin Bar
B. Capscrews G. Lockwasher
C. Seat Deck H. Nut
D. Wrapper & Spring Assy. I. Capscrew
E. Capscrew