![background image](http://html1.mh-extra.com/html/silverline/196512/196512_original-instructions-manual_1273340008.webp)
GB
8
Symptom
Possible Cause
Solution
Tool operating slowly
Pressure incorrect
Set the correct air pressure according to the specification
Dirt within the mechanism
Pour oil into air inlet as per maintenance instructions
Air blockage
Operate tool in short bursts to clear blockage
Air leak
Check all fittings and hose for air leaks and correct issue by
re-tightening, using PTFE tape or replacing
Blockage in gauze mesh filter
Remove Quick Connector and clean mesh filter
Tool seized
Dirt or rust in mechanism
Try ‘Tool operating slowly’ solutions
Dirt or rust in mechanism
Tap tool gently with a soft mallet
Dirt or rust in mechanism
Free mechanism by rotating drive manually when disconnected from air line
Strong vibrations when tool is
switched on
Disc fitted incorrectly
Remove disc, inspect for damage and refit
Disc damaged (cracks, deformations or splinters)
Replace cutting disc
Flange damaged (burred or notched)
Replace flange
Spindle bent
Have the tool repaired by an authorised Silverline service centre
Tool will not stop after trigger is
fully released
Throttle valve O-ring or valve seat damaged
Have the tool repaired at an authorised Silverline service centre
If the above troubleshooting solutions fail, contact your dealer or an authorised Silverline service centre.
Troubleshooting
196512_Manual.indd 8
30/08/2017 17:20