SWK 360 A1
GB
│
IE
│
NI
│
43
■
NOTE
►
Alternatively, you can use the double-sided tape to mount the arm mount on an object.
Before assembly, remove the strap from the arm mount . When mounting the device, make
sure that you apply it to a clean, fat-free and dry surface.
►
Once you remove the double-sided tape after assembly, it cannot be reused.
Suction cup mount
You will need the following accessories to install the suction cup mount :
+
+
♦
Undo the screw cap on the suction cup mount .
♦
Push the ball joint on the ball adapter into the screw cap on the suction cup mount .
♦
Re-tighten the screw cap on the suction cup mount .
♦
Place the thread on the camera onto the fixture of the ball adapter and screw the camera
tight.
NOTE
►
Before continuing, read the section
Basic safety instructions
.
♦
Push the suction cup firmly onto a window, e.g. the windscreen, and press the locking lever
towards the glass pane. This creates a vacuum and the suction cup is pulled tightly against the
glass. Raise the lever to remove the suction cup from the glass. The suction cup has a tab at the
side, which makes it easier to remove.
