Silicon Graphics TP9100, Installation Instructions And User Manual

Page: 170 / 182

154 007-4382-002
A: TPMWatch Event Monitor and Logger
Note: A minimum of two parameters must be specified, one of which must be
DeviceFile. If only the DeviceFile parameter is specified, TPMWATCH will not start, and
the syntax usage message will be reported.
Table A-1 Record Layout
Byte # Size Description
0 8
Polling date in YYYYMMDD format.
8 6
Polling time in HHMMSS format (24-hour clock).
14 1
Subsystem summary status. Set to + if all is OK, - otherwise.
15 1
Fan Status: + if All On-Line, otherwise a single digit representing
number of failed fans.
16 1
PSU Status: + if All On-Line, otherwise a single digit representing
number of failed power supply units.
17 1
Temperature status. + if within specifications, - if over-temperature
warning (or temperature sensor failed).
18 1
+ if UPS found and on-line, - if found and off-line, blank if no UPS.
19 1
- if battery is currently discharging, + otherwise.
20 1
+ if no further enclosure alarms, - otherwise (this tests all ESS pages
for any alarm state and detects such things as a FC path failure).
21 2
Master/Slave controller status (see Table A-2).
23 4
Partner State (see Table A-3).
27 32 x 1
Status of each possible System Drive (LUN):
+ If On-line
- If Off-line (and defined)
C if Critical (and defined)
? if in unknown state