Silicon Graphics TP9100, Installation Instructions And User Manual

Page: 167 / 182

Running the TPM 1.2 Version of TPMWatch From IRIX
007-4382-002 151
-L:
Send events to system log file.
An example syntax is:
/opt/dam/tpmwatch -D /hw/scsi/sc37d0l0 -P 10 -L &
Note: A minimum of two parameters must be specified, one of which must be
DeviceFile. If only the DeviceFile parameter is specified, TPMWATCH will not start, and
the syntax usage message will be reported.
Running the TPM 1.2 Version of TPMWatch From IRIX
To run TPMWatch, make sure the $DAM_HOME environment variable is set, and you
invoke the program from root. The syntax is:
tpmwatch [-P Freq] [-d] [-e] [-i] [-s] [-w] [-H HistFile] [-T
LogFile] -S StatusFile -D DeviceFile [-M Addresses] [-L]
Where:
-P Freq:
Frequency in seconds between each poll
-C Freq:
Frequency in hours to autosave configuration
-d:
Enable debug mode to stderr
-e:
E-mail error messages (requires -E flag and 7.X FW or above)
-i:
E-mail informational messages (requires -E flag and 7.X FW or above)
-s:
E-mail severe messages (requires -E flag and 7.X FW or above)
-w:
E-mail warning messages (requires -E flag and 7.X FW or above)
-H HistFile:
Optional event history file. Do not supply this parameter if you do not
wish to create a history file.