62
Siemens Building Technologies
Fire Safety & Security Products
08.2006
Operation User
command
Notes
Return Preset Sequence
Information
@39
Returns preset sequence last downloaded to the XTU. Note that this
data is the last which was sent to the XTU and, for example if the
sequence was subsequently re-programmed using the OSD, it may
not be the same as the sequence stored in the Dome unit.
Return Preset Tour Information
@40
Returns preset tour last downloaded to the XTU. Note that this data
is the last which was sent to the XTU and, for example if the tour
was subsequently re-programmed using the OSD, it may not be the
same as the sequence stored in the Dome unit.
Camera Function All On
@41, n
Supports Lamps (n=6), LensSlow (7), AutoFocus (8).
Camera Function All Off
@42, n
Supports Lamps (n=6), LensSlow (7), AutoFocus (8).
Camera Setup (OSD menu
command)
@47, n
Sends the OSD menu command for Set (n=0), Up (1), Down (2),
Right (3), Left (4), Menu (5).
Return Software Version
@55
Returns XTU software version number (major and minor numbers).
*) The presets used to access the OSD are programmable via the XTU.
The following responses are implemented
OK
Command actioned correctly
ER
Syntax error or parameter error
NC
No control permitted
NI
Command not implemented
CS
Checksum error
Some commands return more information as detailed in the PCCON specification.
These are @1, @26, @39, @40 and @55. In addition, if a checksum is sent with
the command it will be returned in the response. (See the full PCCON3
specification for details).
If the protocol is set to 'PCCON 1-Way' no responses will be returned under any
circumstances.
If the protocol is set to PCCON multidrop, @3 must be used to select the required
camera before any commands will be processed.
Summary of Contents for Solaris CCDS1415-DN
Page 73: ......