FEC920: USER GUIDE
Page 102
September 18
6.10.1 Configuration display
As shown in Figure 90, highlight the required DC output, then operate the scroll button to reveal the
configuration page.
Figure 90 DC Output option configuration page (typical)
PARAMETERS
Type
Select V(olts) (3A3B only) or mA as the output type.
PV
Input value to the function. Normally ‘wired’ to a suitable parameter.
Status
The status of the input parameter.
OP Adjust State
Adjusted. Appears only if the Output Adjust facility (Section 6.1.10) has been used.
Resolution
The number of decimal places to be used for this configuration item.
Output Low
The minimum output value in Volts or mA as appropriate.
Output High
The maximum output value to be output in Volts or mA as appropriate.
Scale Low
See ‘SCALING INFORMATION’ below.
Scale High
See ‘SCALING INFORMATION’ below.
Fallback PV
The output value when the status of the input parameter is not ‘good’.
Measured Value
The Voltage or mA value appearing at the output terminals
Note:
The output voltage or current can be calibrated by using the output adjust procedure
described in Section 6.1.10.
V
0.00
Good
Adjusted
2
0.00
10.00
Type
PV
Status
OP Adjust State
Resolution
Output Low
Output High
DC Output.3A3B (DC Op)
Scale Low
Scale High
Fallback PV
Measured Value
0.00
100.00
0.00
0.00
Appears only if
the DC Output
has been
adjusted
(Section 6.1.10)
Select configuration menu
Network
Group
Channel
Virtual Channel
Loop
Digital I/O
DC Output
3A3B (DC.Op)
2A2B (DC.Op)
1A1B (DC.Op)
A5E45696052A Rev-AA
