Siemens SIMATIC S7 F, Manual

Page: 289 / 354

Fail-Safe Blocks
Fail-Safe Systems
A5E00085588-03
8-101
Note
If, when you create the program, you preset the Q output in CFC with the initial
value 1, it will remain set after startup (cold restart or warm restart) until the signal
state at the R input changes to 1.
Note that the initial values of output parameters do not appear in the printout of the
CFC chart. They must be checked in the printout of the safety program.
Error Handling
In the event of an error that is critical to safety, the system function SFC F_CTRL
is called. This records the event in the Diagnostic Buffer and requests a switch to
the reserve CPU if the error occurred only on the master CPU. For non-redundant
systems or a common-cause error occurring in both CPUs, the shutdown logic can
be configured to either disable the erred F-run-time group or the entire Safety
Program.
Error Information in Diagnostic Buffer
Error Code (W#16#...) Description
75DAH Error in the safety data format of inputs S and R (error due to
online modification of the Safety Program or internal CPU
fault)