8.3
Replacing an I/O module
Introduction
The first time you insert an I/O module, part of the coding element locks into the terminal block.
If you replace an I/O module with the same module type, the correct coding element is already
in the terminal block.
You can find information on the coding element in the section "Inserting I/O modules or slot
Module identification - read and transfer data
If data have been configured for module identification in the plant, you must transfer this data
after plugging a module in again.
● Data transmitted to the I/O module for the module identification can be read back into the
project.
Configure the I/O module in HW Config and select the menu command CPU > Upload
Module Identification to PG... .
● Transfer any data for module identification in the configuration after plugging in the I/O
module.
Configure the I/O module in HW Config and select the menu command CPU > Upload
Module Identification... .
Requirement
● Read the section "Plant planning (Page 23)".
Maintenance
8.3 Replacing an I/O module
ET 200SP HA Distributed I/O system
120
System Manual, 08/2019, A5E39261167-AD
Summary of Contents for SIMATIC ET 200SP HA
Page 6: ...Table of contents ET 200SP HA Distributed I O system 6 System Manual 08 2019 A5E39261167 AD ...
Page 181: ...Glossary ET 200SP HA Distributed I O system System Manual 08 2019 A5E39261167 AD 181 ...
Page 182: ...Glossary ET 200SP HA Distributed I O system 182 System Manual 08 2019 A5E39261167 AD ...
