Siemens Set CEM CERT, Operating Instructions Manual, Page: 55 / 128

Operation
8.4 Menu-based operation
Set CEM CERT
Operating Instructions, 06/2021, A5E34491309-12
53
8.4 Menu-based operation
8.4.1 Measuring mode
After switch-on, the measured value overview with the display of measured values
appears.
This is the standard view of the HMI. You can jump to here from any other menu with
function key <F1>.
Depending on the number of measured components, up to 8 measured values can be
displayed in this menu. The following parameters are displayed for each component:
• Measured component
• Measured value
• Unit of the measured value
• Status of the measured value
• Small trend graph of the measured value
Clicking a measured value takes you to the device view for the analyzer involved.
Clicking a graph display takes you to the Graph menu where the trend graph can be seen
in full size. The mini-graph display is used for checking the active status of the measured
value; the measured value should never be constant. The graphs are updated with a new
measured value every second.