10–14
10–15
EWA 4NEB 812 6096–02b
EWA 4NEB 812 6096–02b
ET 200 Handheld
ET 200 Handheld
SL$$ #########
¹
Dia K:#/#
Dia #####1##
###############
Continued
from previous page
and bit 2 = 1
Header No #
³
###########
I/Q #### SL##
³
CH##
³
######
³
Identifier–specific/
Device–specific d.
channel diagnostics
Dev 00 01 02 03
³
Dia ## ## ## ##
I/Q #### SL##
³
CH##
######
³
You can change over to the following displays provided bit
“2” is set and the cursor is positioned on “bit 2”:
Header No.: You can select the existing diagnostics mes-
sages with the cursor keys. The abbreviations have the fol-
lowing meanings:
DeviceDia
Device–specific diagnostic bits have
been reported.
SlotDia
Identifier–specific or channel diagnostic
bits have been reported.
The Header No. is not displayed unless device–specific
diagnostic bits as well as identifier–specific/channel dia-
gnostic bits have been reported. Otherwise the ET 200
handheld branches immediately to the diagnostics message.
Use the cursor keys and
for branching to device–speci-
fic or identifier–specific/channel diagnostics.
Device–specific diagnostics: Device–specific diagnostics
comprises up to 25 bytes. For length and significance of
device–specific diagnostics, please refer to the DP Standard
Slave manual.
Line 1 indicates the byte position, line 2 displays the corre-
sponding values as hexadecimal numbers.
“
²
” or “
³
” indicate that there are further data to the right
or to the left of the area displayed; you can use the cursor
keys to select these data.
Leaving the display: Press
to exit this display.
DP Standard Slave
DP Standard Slave
