Configuration
57
Building Technologies
048_CCDA1445_A6V10257135_V1.0_en
Fire Safety & Security Products
20.08.2009
10.3.1.3
LINE LOCK
MODE
LINE PHASE
OFF
180
Menu item
Option settings
MODE
Line Lock can be set to ON or OFF. In case Line-Lock is set to
OFF, the synchronization is internally via crystal oscillator.
LINE PHASE
The Line Lock Phase can be set from 40 to 250 degrees.
The high-speed dome cameras can be synchronized with the power supply
frequency.
10.3.1.4
PRIVACY ZONE
This function masks a user-defined area that cannot be viewed by the operator.
The mask adjusts with the pan, tilt and zoom of the camera.
Masking areas are only rectangles.
Although the privacy zone works in digital zoom, the zone setting is only available
in a non-digital zoom area.
It is recommended to set privacy zone bigger than actual masking area.
In turbo mode the privacy zone may shift depending on the location of the zone.
The positioning accuracy of privacy zones depends on the tilt angle of the dome.
It is not possible to place privacy zones in areas where tilt angle is 0 – 20°.
Privacy zone setup
1.
Enter “76” on the keyboard.
2.
Press <MEM>.
Ö
The following setup screen is displayed: PRIVACY ZONE 1 MIN
3.
To select the zone (1 – 8) move the joystick up or down.
4.
To select MIN or MAX move the joystick left or right.
−
MIN: the zone will be set to the minimum size.
−
MAX: the zone will mask the entire image on screen. The actual size is
slightly bigger than monitor image.
5.
To cancel the selection and leave the submenu press <∞> (focus far).
6.
To accept the selection press <O> (focus near).
7.
To set the height of a privacy zone move the joystick either up or down and
hold it until the privacy zone has the desired height.
8.
To set the width of a privacy zone move the joystick either to the left or to the
right and hold it until the privacy zone has the desired width.