SIEB & MEYER CNC 0610510, Hardware Description

Page: 51 / 101

:
Functional Description of the Connectors/Interfaces
CNC 61.00 Hardware Description CNC 0610510/12 51
8.2.10 Inputs and Outputs of the Logic Signals
All inputs and outputs work with a level of 24 V. The total load of all outputs must not
exceed 350 mA. Please consider that some inputs and outputs have alternating
meanings according to the configuration. If, for example, the function "Motor brake"
has been activated in the parameter editor (IP_E_BRAKE=ON), the output o1 will au-
tomatically be identical with the function "Motor brake".
8.2.10.1 X50 - Internal Inputs
X 10-pole Mini CombiCon (PHOENIX)
8.2.10.2 X51 - Internal Outputs
X 10-pole Mini CombiCon (PHOENIX)
Pin Designation Function "Normal“ Function "Nut runner“
1 24 V are applied
2 0 V
3* IN7
4 IN6
5 IN5
6 IN4
7 IN3
8 IN2 limit switch -, if IP_E_END = ON first variant
9 IN1 limit , if IP_E_END = ON start
10 IN0 always emergency stop always emergency stop
* Pin 3 is coded.
Pin Designation Function "Normal“ Function "Nut runner“
11 OUT7
12 OUT6
13 OUT5
14 OUT4
15 OUT3 NIO
16 OUT2 IO
17 OUT1 motor brake, if IP_E_BRAKE = ON ready
18* OUT0 controller OK controller OK
19 RIO- potential-free contact switches synchro-
nously to OUT 0 potential-free contact switches synchro-
nously to OUT 0
20 RIO+
* Pin 18 is coded.
L
The assignment of the inputs and outputs depends on the application
and on the function (Normal/nut runner). Predefined inputs and out-
puts, such as emergency stop, or the inputs
Start , IO and NIO of the
nut runner, should not be programmed differently in the application.